232 line driver

RS Line Driver 2 _____ ABSOLUTE MAXIMUM RATINGS ELECTRICAL CHARACTERISTICS (VCC = V to V, VEE = V to V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.) Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. RS Line Driver/Receiver Data Sheet ADME FEATURES kV fully isolated (power and data) RS transceiver iso Power integrated, isolated dc -to-dc converter. kbps data rate. 1 Tx and 1 Rx. Meets EIA/TIAE specifications. ESD protection on R. IN. and T. OUT. pins. The MAX device consists of one line driver, one 1• RS Bus-Pin ESD Protection Exceeds ±15 kV Using Human Body Model (HBM) line receiver with dedicated enable pin, and a dual charge-pump circuit with ±kV ESD protection pin • Meets or Exceeds the Requirements of to pin (serial-port connection pins, including GND).

The TRS consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±kV ESD protection terminal-to-terminal (serial-port connection terminals, including GND). The device meets the requirements of TIA/EIAF and provides the electrical interface between an asynchronous communication controller and the serial. Line Drivers: RS// The RMC SERIAL module supports three different line drivers: RS, RS, and RS The line driver is selected through RMCWin. The following chart compares these three line drivers: Differential? * Four-wire RS can be full-duplex if the topology is point-to-point. It can also be somewhat full-duplex in a. TI’s MAX is a 3- to V single channel kbps RS line driver/receiver with +/kV ESD protection. Find parameters, ordering and quality information.

www.doorway.ru:ZZ SPECIAL FUNCTIONType Pins Description 14 RS line driver Add to wishlist. In Stock Notification: You. Fully Isolated RS Line Drivers. Description. The LDM70 series of products is designed to allow video display terminals. DTs and other RS devices to be. Overview. MAX is a 3V to V multichannel RS line driver/receiver. It consists of two line drivers, two line receivers, and a dual charge-pump circuit.